Mount the bracket
Remove two license plate screws and install the bracket above license plate
THE UNIVERSAL THIRD BRAKE LIGHT
The light your rear end was missing.
A clean, universal license-plate-mounted third brake light built to stand out without drilling into your bumper.
No drillingUses existing plate mounting points
Universal fitDesigned around standard license plates
Bright outputThree marker-style LED lights (12V/24V)
Clean installMinimal, intentional wiring
First production run
3rd Brake Light (Universal)
Handcrafted in California, this low-profile bracket mounts three red marker lights above your license plate.
What's included
- Aluminum Bracket
- 3x Marker Lights
- Posi-Tap connector
- 5ft of wire
Note
- Comes fully assembled
-
Mounting screws are not included. Reuse your OEM screws or purchase two matching screws approximately 20 mm longer.
- Installs using your existing license-plate mounting points
- Designed for a low-profile factory-plus appearance
- Support directly from TerraTek
INSTALLATION
Three steps. Clean result.
Cut Bracket Wire
Bracket includes 5 ft of wire. Trim to the length needed for your connection point.
Connect to Power
Attach the Posi-Tap to the bracket wire, then tap it into your taillight’s brake-power wire.